Search titles only.

6) With the King Pin installed, the notch in the pin should be visible through the small horizontal hole in the axle. Slide the lock pin into the hole threaded end first, making sure that the pin locks into the notch on the King Pin. The threaded end of the lock pin should point toward the rear of the car. bushings (C), and install bushings, aligning the grease channels (D) in the bushing with the grease fittings (A). AC Figure 9: Install the Spindle and Thrust Bearing NOTE: Install the thrust bearing with the dust shield up (toward the axle).

3. See Figure 9. Install the spindle (B) and thrust bearing (E) on the axle (G). Check the. now properly install the c-notches. Using the diagram above measure 4” forward from the face of the cross member.

This will be the center of the c-notch. Now measure up the rail ” and mark it. Use the c-notch as a template on the frame using the mark on the frame as the center/top of the c-notch. Cut the frame to match the c-notch. Oct 17, the bushing mm ( in) from the top seal on the top. Position and support the and bottom of the bores.

steering knuckle assembly on the axle end. For axles coded 02ADC-K, use the bottom The ride on stump grinder style thrusting is a one-piece design figure mm ( in) from the top and with the seal lip installed towards the bottom ofFile Size: KB.

Oct 13, Removing the OE Bushing. Before you can install your new bushing, you have to remove the old one. If you need help removing your OE bushing, check out our How-To Burn Out Bushings: The Right Way article.

Be sure to consult your installation instructions before you remove the outer shell, as a lot of aftermarket bushings require the use of the OE shell.Estimated Reading Time: 7 mins. Oct 23, Incorrect installation of attachment parts. Attachment parts are often installed incorrectly or not at all (e.g. spring plates, bushings, etc.). A missing support washer on a suspension strut bearing, for example, can damage the vehicle or the suspension. Shock.