Slightly different motor than mine, had the screw in type.
May 17, Best to have the L/U secured in a vise so it doesn't move about and jar the shift shaft. Push down firmly on the shift shaft as you're pulling the bushing up-and-off. Otherwise, Bad Things will happen! Never Fear, it is a recoverable error, and there is a way to get the shift shaft reiinstalled without dismantling the L/stumpcleanup.barted Reading Time: 9 mins. These tool set is time saver to remove worn shift shaft bushing with no the inner primary removing need, swapped out the bushing in approximately 20 minutes.(Also help install the new bushing) Pretty easy and quick work to do with this tool if you need remove and install your own bushings/5(15).
JIMS Shift Pedal Shaft Bushing Tool - For models listed w/5- or 6-speed transmission. Time-saving tool removes worn shift shaft bushings in Big Twin primaries without having to remove the inner primary. Tool also will install new bushings to the correct location.
Bushings can be swapped out in approximately 20 minutes using this tool - a huge time saver.5/5(18).
Search Advanced search….
Jul 12, Discussion Starter #8 Jul 12, Breeze3at said: I just looked at a '93 diagram, and B is the bushing for the shaft that goes behind the heel/toe shifter.
H5 may be a color or material code. While I had my shaft out, I drilled & tapped the case for a zerk fitting. Now it gets greased. Problem fixed: Bushing was worn.
1. Remove the 6 screws that hold the lower gear housing together. 2. Remove propeller shaft and gears. 3. Remove the driveshaft and the shift rod. 4. Use the bushing removal to tap out the old bushing. 5. Remove the things that fall off trees and spin o-ring 6. Put in a new o-ring. /5(37). The Sierra Shift Shaft Bushing Tool is interchangeable with the following: GLMMercury T,T,Each Sierra product meets or exceeds the original equipment part it replaces.
Sierra Shift Shaft Bushing Tool Meets or exceeds the original equipment quality Sierra part number: /5(13). Jun 02, Use an 8 mm wrench and needle nose pliers to remove the lag bolt that holds the shift rod to the coupler.
Use an 8 mm open-end wrench to remove the square setscrew that holds the coupler to the transmission. Now comes the fun part; you need to push the shift rod towards the front until it clears the bushing support. Jims USA Shifter Shaft Sleeve Installation & Removal Tool. This tool allows you to remove and install Harley-Davidson # shifter shaft sleeve without removing the transmission case from the chassis.
This tool installs sleeve to the correct depth in case without error or damage.
Use to install shifter shaft sleeve.