DMiller and RZucker like this.

Jan 05, Use your hammer and chisel to remove the wood at the middle of your notch. Work slowly and efficiently. Place the wood flat on your working table and start chiseling from the top going down to the middle of the notch. You may also cut notches by using a chop saw or miter stumpcleanup.barted Reading Time: 4 mins. Feb 08, The bushing are for the swing cylinder trunnions on a backhoe. CNH wantsplus tax for two hardened steel bushings. 2 1/2" ID x 3" OD x 3/4" L.

Dale Wiess has some 1 1/2"L.

The crop marks should be spaced approximately 1 cm apart.

forIs there a way to cut it in half nice and square? Angle grinder? Are there blades for reciprocating saws that would cut it? Oct 02, You only want to cut the old bushing shell.

A thin line through the original bushing shell is enough to relieve the tension, which will allow you to remove the shell more easily. Cut a thin line through the OE shell, making sure not to cut the housing. Push out the Sleeve. The largest pressing fixture of the tool has a notch cut out so that it can clear part of the diff. You may need to rotate the largest fixture to get the notch in the correct cutting thick bushes. The bushing is pressed in with some force and with two ¾” combination wrenches, it took about all my strength to press out the old bushing.

Dec 06, Cut the bolt head and nut off with cut off tool, drilled out most of the bushing, sawzall to cut notch in metal, hammer and chisel to bend the housing. I would probably drop the axel next time. you can make your first test cut, see Steps 2 through 4. 4Mount &/16” guide bushing onto router.

Then to start with, raise bit!/2” from router base. It may have to be adjusted slightly later on.

2With the test pieces in the jig, adjust the stop so the edge of the front test piece is centered in the first notch or opening of the template.