Sometimes it might take up a lot of time, but.

Jun 25, An excellent way to clean a blending stump is by using a kneaded rubber eraser used for drawing. This will help remove any graphite or charcoal from your blending stump if you move it in small circles until it’s all gone. Make sure you twist and rotate the stump to make sure all sides are clean. May 09, How to clean your old and dirty blending stump.

Paper stump cleaning technique. Tortillon or blending tool clean stumpcleanup.bar Stump Set - stumpcleanup.bar To clean a blending stump, start by rubbing a clean area of a kneaded eraser around the tip.

If you use a clean blending stump, you will get light value strokes in the drawing.

This will help remove a lot, if not all of the graphite. If your blending stump is still dirty, use a piece of sandpaper to slowly sand away the paper at the tip. It’s important to remember that your blending stump is made out of stumpcleanup.barted Reading Time: 8 mins. Jun 10, In my experience, blending stumps can be cleaned fairly well by molding a kneadable eraser around the tip and twisting them inside the eraser several times.

If it doesn't get most of the graphite, etc. off the first time, knead in the graphite and repeat as necessary.

Blend and smooth dusty media using smooth rice paper stumps. Rice paper has a smooth surface that's perfect for blending. Tips range from the ultra fine mm to mm. Clean and re-point your stumps with sandpaper. Three paper stumps per pack.

New (6) fromFREE Shipping on orders overshipped by Amazon/5(K). Apr 19, Use a Kneaded Eraser This can be done by applying the kneaded eraser to the dirty area of your paper blending stump in small circles with pressure until it’s clean again.

Make sure to rotate and twist the stump inside the kneaded eraser for the latter to completely remove the dirt. How do you sharpen a blending stump without sandpaper?

Prevent oily hand residue from finger blending and use Creative Mark’s Blending Stumps instead! These traditional double-ended blenders are manufactured from soft paper felt and make short work of blending. You can easily clean the stump by sharpening dirty portions off on a sanding stumpcleanup.bar: Creative Mark.

Jun 25, A blending stump is a stick of tightly rolled paper that is sharpened at one end like a pencil. It is used to blend graphite and charcoal to create a seamless and ralistic shading effect. It’s also used as an illustrative technique in comics, where the artist will smudge pencil lines with a blending stump to create grey tones and add depth.

Jan 27, By Blending I mean pushing graphite or charcoal areas back and forth with a clean stump so the values get connected in a certain way. Do this very slightly at first to get a feeling for the method and not ruin your drawing. You can also try it on a scrap paper at first of course.