You are doing this to get to the emergency brake and its 3 bolts that.

Replacing the axle pivot bushings on the Ford TTB axle beam can be a real chore for some people. Some people even think the only way to get it out is to burn it out with a torch.

These photos show doing it to a Dana 28 from a 4×4 Ford Ranger / Bronco II, but the same idea will work on the Dana 35 TTB, Dana 44 TTB, and Dana 50 TTB. Front Axle Pivot Bushings will fit the Ford F, F, F, and Bronco as well as the Explorer and Ranger. These axle pivot bushings tighten the Twin-Traction Beam axle's connection to the frame and can reduce steering wander and looseness. May 14, Remove the front spring.

Remove the front stabilizer bar, if equipped.

Remove the spring lower seat from the radius arm, and then remove the bolt and nut that attaches the stabilizer bar bracket, if equipped, and the radius arm to the (I-Beam) front axle. Remove the axle-to-frame pivot Estimated Reading Time: 6 mins.

Mar 26, Buy a Ford Ranger Axle Pivot Bushing at discount prices. Choose top quality brands AC Delco, Dorman, Energy Suspension, Moog, Quick Steer, Superlift, Suspensia, TRW. Ford RangerFront Axle Pivot Bushings by MOOG. Replace your worn or damaged bushings with stronger and longer-lasting bushings from MOOG that effectively absorb substantial loads and are less prone to splitting or cracking with Restore handling and.

Removal. Remove axle. Refer to Dana Four-Wheel Drive Front Drive Axle Removal and Installation in this section. Install Suspension Bushing Service Set T78PA1, Bushing Remover T80TA1 and Receiver Cup T78PA3 onto the pivot bushing. Turn the forcing screw and remove the pivot bushing. Installation. Place pivot bushing in axle housing.